Re: Worldwide Feedback Pouring in... VoiceMax a Huge Success!

Why Do You Need a Speech Processor for Your CB Radio?
Two-way radio communication relies on the modulation contained within
the signal. Maintaining a high modulation level is crucial in
providing the highest possible efficiency from any transmitter
operating on AM, FM, or SSB modes. Two-way radios also rely on
microphones that inherently change audio levels delivered to the
transmitter. This causes transmitter modulation to fluctuate greatly
depending on voice level and pitch. The average modulation of a
typical voice signal is only about 40%. This low percentage applied
to
the transmitter, results in less than optimal transmission range.

Other Processors Have a Problem...
Other speech processors use a low-cost "audio clipping" approach to
achieve compression. While this method is economical for the
manufacturer, clipping distorts the original signal and sounds fuzzy
on the air. What these types of audio processors gain in volume, they
lose in voice intelligibility.


VoiceMax is Different...
VoiceMax uses a sophisticated AGC (Automatic Gain Control) circuit
that installs inside your transceiver to hold the audio level
constant, with less than 1% harmonic distortion. No "clipping" type
processor can come close to this low distortion level. Whether you're
whispering or shouting, VoiceMax holds your transceiver at 100%
modulation allowing you to punch through heavy channel traffic
without
sacrificing voice clarity. VoiceMax incor****ates a feature not
offered
on other processors. The adjustable noise gate allows the user to
block unwanted ambient background sounds. This feature is especially
helpful in mobile environments where wind and road noise can be an
issue. VoiceMax works with your non-amplified dynamic microphone to
give you tremendous audio punch without all the background noise
associated with power microphones.


www.telstar-electronics.com